Transmission; Transmit Time-Out; Timer (Tot); Distance - Standard Horizon HX270E Owner's Manual

5.3 TRANSMISSION

Never key the transceiver without an antenna connected, as this may
cause damage to the transceiver.
1. Perform steps 1 through 7 of the RECEPTION discussion above.
2. Before transmitting, monitor the channel and make sure it is clear.
3. For communications over short distances, press the H/L key until "
displayed on the LCD. This indicates Low power (approximately 1 Watt).
Transmitting on 1 Watt prolongs battery life. Low power (1 Watt)
should be selected whenever possible.
4. If using Low power is not effective, select Medium power (2.5 Watts) or
High power (5 Watts) by pressing the H/L key until
" " (Medium power) or "
played.
5. When receiving a signal, wait until the incoming signal stops before trans-
mitting. The transceiver cannot transmit and receive simultaneously.
6. Press the PTT (Push-To-Talk) switch to transmit. The "TX" indicator is
displayed during transmission.
7. Speak slowly and clearly into the microphone. Hold the microphone about
½ to 1 inch away from your mouth.
8. When the transmission is finished, release the PTT switch.
5.4 TRANSMIT TIME - OUT TIMER (TOT)
The HX270E is capable of PC programming TRANSMIT TIME - OUT
TIMER (TOT) by a dealer. Contact your dealer for further details.
While the PTT switch is held down, transmission time is limited to 5 minutes.
This prevents prolonged (unintentional) transmissions. About 10 seconds
before automatic transmitter shutdown, a warning beep sounds from the
speaker. The transceiver automatically switches to the receiving mode, even
if the PTT switch is held down. Before transmitting again, the PTT switch
must first be released, then pressed again. This Time-Out Timer (TOT) pre-
vents a continuous transmission that would result from an accidentally stuck
PTT switch.
Page 14
NOTE
NOTE
" (High power) is dis-
" is
HX270E