Operation; Initial Setup - Standard Horizon HX270E Owner's Manual

5. OPERATION

5.1 INITIAL SETUP

1. Install the belt clip on the transceiver, if desired.
2. Install the battery pack on the transceiver (see
figure 1 and section 3.2).
3. Install the antenna onto the transceiver.
Water resistance of the transceiver is assured
only when the battery pack and antenna are
attached to the transceiver.
1. Connect the hanger to the rear of the HX270E, with the notch point-
ing directly up, using the supplied screw (Figure 6-a).
Use only the screw included
with the clip to mount the clip
to the back of the transceiver!
2. Clip the Quick Draw Belt Clip to
your belt (Figure 6-b).
3. To install the HX270E into the
Quick Draw Belt Clip, align the
hanger with the Quick Draw Belt
Clip and slide the HX270E into
its slot until a click is heard.
4. To remove the HX270E from the
Quick Draw Belt Clip, Rotate the
HX270E 180 degrees, then slide
the transceiver out from the Quick
Draw Belt Clip (Figure 6-c).
Page 12
NOTE
Installing the Quick Draw Belt Clip
Figure 5
Antenna Installation
HX270E
(a)
belt
(b)
Figure 6
(c)
HX270E