HCD-DX20/RG30
Ver1.2 2003.01
REMOVING THE PANEL BOARD AND THE KEY BOARD
* The panel board and the key board only are connected to the front panel
by means of hot-melting the plastics.
2 Cut the seven melted-connection points
with a cutting plier.
In order to re-install the panel board and the key board,
fix them by using the screws (+BVTP 2.6 × 8 ) respectively.
Screw in to the respective screw holes.
Do not tighten the screws excessively.
NOTE FOR CHASSIS EXCHANGE
Apply HANARL SLF-9 (7-400-000-00) to the
position of the figure.
4
SECTION 1
SERVICE NOTE
3 Panel board
1 Connector
13p (CN712)
Note for installing the panel board and the key board
Panel board
(ten screw holes)
5 Key board
4 Cut the six melted-connection points
with a cutting plier.
Key board
(eight screw holes)
Screw hole
Hot melt
: Apply HANARL
Chassis