Table of Contents
Advertisement
D.
Pull belt tight and secure belt to clamp with the two
set screws. NOTE: Torque set screws 300-350 in.lbs.
See Figure 9.
E.
Place weight stack pin in each plate to verify proper installation.
F.
Without selecting any resistance, lift top weight up
and down (simulating normal operation).
G.
Have an assistant verify that the belt is moving smoothly and
is routed straight from the top pulley bracket to the
top weight belt clamp.
H.
Reinstall the six increment weights that were removed
in step 6B. See Figure 10.
I.
Turn the Increment Weight Adjusting Kob to select all
15 lbs.
8. Install back shrouds.
A.
Carefully place shroud assembly back into position
on the two bottom screws. See Figure 11.
B.
Install the top two screws securing the back shroud
assembly. See Figure 12.
C.
Install the three Phillips head screws securing the
top (back) shroud. See Figure 13.
Assembly
Page 4-4
Cybex Eagle 11100 Back Extension Owner's Manual
Belt
Set screw
Figure 9
Grooves
Increment Weights
Figure 10
Figure 11
Figure 12
Phillips Head
Screw (3)
Figure 13
Belt clamp
insert
Belt clamp
Screw
Screws
Advertisement
Table of Contents
