Advertisement
Inflation Valves & Pumps
Recessed Air Valves
Remove the cap and
press and turn the valve
stem counterclockwise
so that the stem is in
the UP position. Only
when the stem is in this
position the valve will
retain air. Turning the
stem clockwise will put
the valve in the down
position for deflation.
Foot Pumps
Press the two halves of
the foot pump together
and connect the hose to
the inflation port marked
OUT. Insert the valve
adapter at the other end
of the hose. Please note
the A-50 foot pump has
two settings. One for
high volume and the
other for high pressure.
A-50 Foot Pump
A dual chamber foot
pump which has two
settings, high volume
for the main chambers
and high pressure for
the drop stitch inflatable
floor and the keel. The
A-50 is included with
models featuring the
drop stitch floor.
A-50 (high volume)
When the black cap is
inserted into the center
of the A-50 the pump is
in the high volume set-
ting. Use this setting to
inflate main chambers
of the boat to 3.2 PSI.
Inflation Valves & Pumps
4
A-50 (high pressure)
When the black cap is
removed from the cen-
ter of the A-50, the
pump is in the high
pressure setting. Use
this setting to inflate the
drop stitch inflatable
floor and the rigid inflat-
able keel to 7 PSI.
Recessed Adapter
The recessed valve
adapter is located inside
of the orange repair kit
canister. Insert the
ribbed end of the valve
adapter into the hose on
the foot pump. This
valve adapter is not
compatible for use with
electric pumps.
Before inflationg make
sure that the stem in-
side of the valve is in
the UP position so that
the chamber retains air.
Insert the valve adapter
and turn clockwise to
lock into position. When
the pressure (3.2 PSI) is
reached you should feel
resistance on the foot
pump.
Advertisement
