Care And Cleaning - GE Monogram ZVB30 Owner's Manual

Grease filters
Painted or
stainless
steel
surfaces
The efficiency of your downdraft depends on a
clean filter. Frequency of cleaning depends on the
type of cooking you do. Grease filters should be
cleaned at least once a month. Never operate the
downdraft without the filters in place.
To remove: Slip fingers into the vent holes, lift the
vent straight up and pull forward. Grasp the filter
tabs, push down and out of the retainer.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove
embedded soil. Rinse, shake and remove moisture
before replacing. Do not clean the filters in the
dishwasher.
With careful handling, the filter will last for years.
If replacement becomes necessary, order the part
from your dealer.
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm,
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the grain.
Follow the cleaner instructions for cleaning the
stainless steel surface.
For difficult stains on stainless steel, use a cleaner
that contains lactic acid or citric acid.

Care and Cleaning

Downdraft Vent System
Filter Tabs
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center
GEAppliances.com
800.626.2002 (U.S.)
7