Care And Cleaning - GE Monogram ZDIC150 Owner's Manual

Ice maker
CLEANING NEEDED will illuminate when the
system care
electronic control senses that the need for
cleaning is approaching. At this time you need to
purchase Nickel Safe Ice Machine Cleaner by Nu
Calgon, available at most appliance repair shops
or through GE Parts and Accessories. Order
part number WX08X42870. In the U.S.A., call
1.800.626.2002. or visit GEApplianceParts.com.
In Canada call 1.800.561.3344. The ice maker
must be cleaned, otherwise ice production may
decrease significantly or stop.
Exterior
surfaces lightly dampened with mild liquid dish detergent.
Dry with a clean, soft cloth. Do not wipe the ice
maker with a soiled dish cloth or wet towel. These
may leave a residue that can damage the finish.
Do not use scouring pads, powdered cleaners,
bleach or cleaners containing bleach because
these products can scratch and damage the
finish.
Interior
components
power to the ice maker before cleaning. Failure
to do so can result in death, fie, or electrical
shock.
Débranchez l'alimentation électrique à la
machine à glaçons avant le nettoyage.
L'omission de prendre cette précaution peut
entraîner la mort, l'incendie ou le choc électrique.
1. Open the storage bin door and remove any ice
that is in the bin.
2. Pull out on the bottom of the cutter grid cover
until the snaps release to remove.
3. Remove ice scoop and ice scoop holder.
Remove the two screws using a 1/4" ratchet.
NOTE: Do not remove hoses. Do not wash plastic
parts in dishwasher. They cannot withstand
temperatures above 145°F (63°C).
4. With mild soap and warm water wash the
storage bin, ice scoop and holder, cutter
Wipe with a clean cloth
WARNING:
Disconnect electrical
AVERTISSEMENT !

Care and Cleaning

Ice maker
REPLACE FILTER will illuminate when the
electronic control senses that the filter needs to
be replaced. At this time you need to purchase a
replacement filter, part number IMWF, through GE
parts at www.gewaterfilters.com or in the US call
1.800.626.2002.
Product designed and tested for use with
genuine GE water filters. Non-GE filters are not
covered under product warranty.
Regularly clean and polish the
stainless steel door panels and handles (on
some models) with a commercially available
stainless steel cleaner such as Stainless Steel
Magic to preserve and protect the fine finish.
™
Order part number WX10X15. In the U.S.A. call
1.800.626.2002 or visit GEApplianceParts.com. In
Canada call 1.800.561.3344.
stainless steel.
grid cover, door gasket, and secured interior
components (cutter grid, exterior of hoses, and
water reservoir). Rinse with clean water.
5. Clean the same parts again with a solution of
1 tbsp. (15 ml) of household bleach in 1 gal. (3.8
L) warm water. Rinse thoroughly with clean
water.
6. Gently wipe the control panel with a soft, clean
dishcloth using warm water and a mild liquid
dish detergent.
7. Replace ice scoop holder.
8. Replace the cutter grid cover by aligning top
tabs and pushing to snap into place.
9. Plug in ice maker or reconnect power.
NOTE: The air cooled condenser needs to be
cleaned regularly for efficient ice production and
energy conservation. See Care and Cleaning -
Condenser section.
9