Honda 08E65-SLN-100 User Information page 11

13
12
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
Remote Control Code Programming
12
13
Press the "LOCK" or "UNLOCK" button on the
remote control transmitter.
• The power door locks cycle to indicate
programming mode.
• To terminate the programming mode at this
point, either turn the ignition key to the
"OFF" position or leave the remote's button
untouched for over 10 seconds. To program
the remote, perform steps 2 through 12.
Press the "LOCK" button of each remote (one
at a line) to be stored in memory.
• The power door locks cycle to confirm
each entry.
• A button on each remote control transmitter
to be programmed must be pressed.
Perform the programming step within 10
seconds for each remote or else the
programming mode will terminate.
NOTE: Only 3 remotes can be stored in the
system's memory.
11