Honda 2010 Civic Coupe Owner's Manual page 128

09/07/07 14:09:25 31SVA640_127
Audio System (Models without navigation system)
Your audio system shows a welcome
message on the display when you
turn the ignition switch to the
ACCESSORY (I) or the ON (II)
position.
You can also customize this welcome
message to your liking with the
audio controls.
To Customize a Message
You can set up to 16 characters on
the display.
To select a character:
1. Make sure the audio system is off.
2. Push and hold the TUNE knob,
then push the power/volume knob
on the audio control panel. You
will see the first letter blinking.
122
POWER/VOLUME
KNOB
EX model is shown.
3. Turn the TUNE knob to change a
letter.
4. Push the top of the SEEK button
to select the next segment, then
turn the TUNE knob to select a
letter. Repeat this procedure to set
your message.
TUNE KNOB
SEEK BUTTON
To change the letter, select the
previous segment by pushing the
bottom of the SEEK button.
The system will return to the audio
display about 10 seconds after you
stop selecting a letter.