Hitachi 28LD5000TA User Manual page 35

OPERATING INSTRUCTIONS (continued)
SETUP MENU
Picture
Audio
Timer
P+
MENU
Function
Setup
Language
P-
Select
OK Set
Selected characters
System
Colour System
AV1
AV2
AV3
AV4
Video Input
Auto
AV1
RGB
AV2 (1st step)
Auto
AV2 (2nd step)
AV4
Setup
OK
Setup
System
Colour System
Video Input
Audio Input
Scart Output
RGB1
RGB2
Setup
System
Colour System
Video Input
Audio Input
Scart Output
RGB1
RGB2
System1 System2
Auto PAL SECAM
NTSC3.58 NTSC4.43
HDTV SDTV/DVD
Composite/Component
HDTV SDTV/DVD
S.Video Composite
System System 1
Colour System
OK
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
P+
P-
System 1
OK
Monitor
DVI-STB
Component
HDTV
Select OK Set Return
P+
P-
System 1
OK
Monitor
DVI-STB
Component
HDTV
Select OK Set Return
Setup hint
Do not change the original setting.
(System1 : Europe/Asia, System2 : North America)
This should correspond to the colour system of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
(Same to AV1)
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
This step should be set only when [Composite/Component] is selected on
the 1st step. And the procedure is same to AV1.
• If the signal from the equipment that is connected to AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.
Setup
Colour System
AV1 Auto
AV2 PAL
AV3 SECAM
AV4 PAL
Select Return Exit
Setup
Video Input
AV1 Auto
AV2 Composite/Component
Auto
AV4 S.Video
Select Return Exit
Setup
Audio Input
AV1 Stereo
AV2 L/Mono
AV3 Stereo
AV4 L/Mono
Select Return Exit
35