Chariot Carriers cougar 2 Owner's Manual page 47

Assembly
lay both the hiking arms with shoulder harness and waist strap
as shown in the "supplied as standard" illustration in front of the
carrier. the waist strap must be attached to the insides of both
arms.
insert each arms into the Versawing 2.0 until the vertical holes
in the arms and Versawing 2.0 are aligned with each other.
the arms should now protrude about 2 cm / 3/4 inch out of the
rear side of the Versawing 2.0.
now secure the arms by inserting the security pin from above
through the vertical hole in the arm and Versawing 2.0 until it
stops. lock the security pin by looping the spring clip over the
pins end that protrudes underneath the Versawing 2.0.
wa r n ing
!
always make sure that the security pin of the hiking arms are
properly inserted to prevent the carrier from accidentally rol-
ling away resulting in an accident in which your passenger(s)
could suffer serious injury or death.
the shoulder strap, which is attached in a similar way to that
of a backpack, can be adjusted in three positions: at the chest
strap at the front,
at the back strap on top for adjusting the height of the waist strap,
and at the waist strap itself.
the holes in the hiking arms are larger than the security pins,
so that the arms can rotate slightly around their longitudinal
axes (in order to adapt to narrow or wide hips, and single and
double width carriers).
T i P