Names And Functions Of Remote Control Unit - Hitachi RAS-51CA3 Instruction Manual

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT

REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
˚ CH
˚ CH
RESET
AUTO
COOL
DEHUMIDIFY
CIRCULATION
FAN
FAN SPEED
LOW
MED
HI
SLEEPING
STOP (CANCEL)
START (RESERVE)
START/STOP
TIME
TIMER SET
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
Signal emitting window/transmission sign
G
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
Display
G
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
START/STOP button
G
Press this button to start operation. Press it again to stop operation.
SLEEP button
G
Use this button to set the sleep timer.
TEMPERATURE button
G
Use this button to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
OFF-TIMER button
G
ON-TIMER button
G
TIME button
G
Use this button to set and check the time and date.
RESET button
G
FUNCTION selector
G
Use this button to select the operating mode. Every time you press it,
the mode will change from
to (CIRCULATION) and to
FAN SPEED selector
G
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from
(during the (FAN) mode, from
AUTO SWING button
G
Controls the angle of the horizontal air deflector.
TIMER control
G
Use this button to set the timer.
RESERVE button
G
CANCEL button
G
Precautions for Use
Do not put the remote controller in the following places.
G
G Under direct sunlight.
In the vicinity of a heater.
G
Handle the remote controller carefully. Do not drop it on the floor,
G
and protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes
G
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
If you press the FUNCTION selector button during operation, the
G
device may stop for about 3 minutes for protection.
Select the turn OFF time.
Select the turn ON time.
(AUTO) to
(FAN) cyclically.
(AUTO) to
HI to
Time setting reservation.
Cancel time reservation.
– 6 –
(COOL) to (DEHUMIDIFY)
(HI) to (MED) to
MED to LOW).
(LOW)