Attaching The Air Purifying Filters - Hitachi RAS-S10CAK Instruction Manual

ATTACHING THE AIR PURIFYING FILTERS

CAUTION
!
Cleaning and maintenance must be carried out when À lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1
Open the front panel
●
Pull up the front panel by holding it at both sides
with both hands.
2
Remove the pre-À lter
● Push upward to release the claws and pull out the
À lter.
3
Attaching the air purifying À lters
● Attach the air purifying À lters to the frame by gently
compress its both sides and release after insertion
into pre-À lter frame.
CAUTION
!
Do not bend the air purifying
À lter as it may cause damage
to the structure.
4
Attach the pre-À lters
● Attach the pre-À lters by ensuring that the surface
written "FRONT" is facing front.
● After attaching the pre-À lters, push the front panel at
three arrow portions as shown in À gure and close it.
NOTE
●
In case of removing the air purifying À lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
purifying À lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying À lters are washable and can be use in 1 year time. Type number for this air purifying
À lter is <SPX-CFH20>. Please use this number for ordering when you want to renew it.
● Do not operate the air conditioner without pre-À lter. Dust may enter the air conditioner and fault may
occur.
Claws
(4 places)
– 17 –