Shutting Down The Projector; Troubleshooting Your Setup - InFocus IN3914 User Manual

Shutting down the projector

Screen Save Time
You can make the black screen appear after a preset number of minutes by turning
on the Screen Save Time feature in the Setup menu. See page 33.
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the
projector off after no active sources are detected and no user interaction with the
projector is performed for 30 minutes. By default, this feature is off. You can
change the length of time, see page 33.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off and the LED blinks amber for 1 minute while the fans continue to run to
cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop.
Unplug the power cable to completely power off the projector.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section. If it does not,
troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector
and can help you troubleshoot.
Table 2: Status indicator light behavior and meaning
Icon
Power, solid amber
Power, blinking green
Power, solid green
Power, blinking amber
Thermometer
Lamp
Wrench/Service
16
Meaning
The projector is plugged in.
The power button has been pressed and the
software is initializing.
The projector is on and initialized.
The power button has been pressed to turn
the projector off and the fans are running
to cool the projector.
The projector is too hot. Make sure the
vents aren't blocked (see page 22). Turn
off the projector and wait one minute, then
turn the projector on again. Contact
Technical Support if the problem persists.
Visit www.infocus.com/support to contact
service.
Turn off the projector and wait one minute,
then turn the projector on again. If the
lamp light turns on again, replace the lamp
and reset the lamp timer.
Turn off the projector and wait one minute,
then turn the projector on again. If the
service lamp turns on again, service is
required. Visit www.infocus.com/support
to contact service.