Life Fitness T3-0 Assembly Instructions Manual page 6

DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO
1.
Remove the tape securing the MOTOR COVER (A) to the FRAME (B).
Carefully lift and remove the MOTOR COVER.
2.
Remove the USER LEFT UPRIGHT (#1) (with grommets installed) from the
ship kit. With the USER LEFT UPRIGHT angled toward the rear of the unit,
align the mounting holes of the flanged end of the USER LEFT UPRIGHT
with those on the top of the FRAME (B). Using two BOLTS (#10), secure the
USER LEFT UPRIGHT to the FRAME. Tighten the BOLTS using a 9/16"
combination wrench until snug and then back them off 1/4 turn. Repeat the
procedure for the USER RIGHT UPRIGHT (#2).
3.
Locate the DISPLAY CONSOLE ASSEMBLY (#3). Unwrap the WIRE
HARNESS (C) secured to the back of the DISPLAY CONSOLE ASSEMBLY.
Standing at the front of the unit, carefully lower the DISPLAY CONSOLE
ASSEMBLY down near the tops of the USER LEFT and RIGHT UPRIGHTS
(#1 & #2). Lower the user right side of the DISPLAY CONSOLE ASSEMBLY to
rest on the USER RIGHT UPRIGHT. Holding the user left side of the DISPLAY
CONSOLE ASSEMBLY slightly above the USER LEFT UPRIGHT, feed the
WIRE HARNESS down into the USER LEFT UPRIGHT through the TOP
CABLE ROUTING HOLE (D) of the USER LEFT UPRIGHT. Once the WIRE
HARNESS is completely inserted into the USER LEFT UPRIGHT, lower the
DISPLAY CONSOLE ASSEMBLY to completely rest on the USER LEFT
UPRIGHT.
NOTE: Be careful not to damage the WIRE HARNESS (C) when routing it
through the USER LEFT UPRIGHT (#1).
REMARQUE : Veiller à ne pas endommager le faisceau de CABLES (C) lors
de son passage par le MONTANT DE GAUCHE (nº 1).
NOTE: Be careful not to pinch the WIRE HARNESS (C) when lowering the
DISPLAY CONSOLE ASSEMBLY (#3) onto the USER LEFT UPRIGHT (#1).
REMARQUE : Veiller à ne pas pincer le faisceau de CABLES (c) lors de
l'abaissement de la CONSOLE D'AFFICHAGE (nº 3) sur le MONTANT DE
GAUCHE (nº 1).
4.
Locate a HANDRAIL (#4) and a TOP HANDRAIL SPACER (#5). Insert a
SHORT MOUNTING BOLT (#6) through the bottom most of the three top
mounting holes of the HANDRAIL. Slide the TOP HANDRAIL SPACER over
the SHORT MOUNTING BOLT as shown until it fully nests over the
HANDRAIL Align and insert the SHORT MOUNTING BOLT into the bottom
most mounting hole of the USER RIGHT UPRIGHT (#2). Tighten the bolt
until snug and then back it off one full turn. Insert two LONG MOUNTING
BOLTS (#7) through the two remaining mounting holes and tighten all three
bolts securely using a 5/32" hex key wrench.
IMPORTANT!
COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT.
A
B
1
10
3
C
D
1
6
B
7
5
6
2
5
7
2
6
4