Installation Instructions; How To Adjust Level - Kenmore 2927000 Service Manual

Table of Contents

Advertisement

2. INSTALLATION INSTRUCTIONS

2-1. HOW TO ADJUST LEVEL

Installation area
1
Install the washer on a firm, flat
surface.
If the washer is installed on an
unsuitable floor, it could make
considerable noise and vibrate.
Set Leveling feet
2
Loosen the locknuts on 2 front leveling
feet until you can turn the feet with the
included wrench. Turn clockwise to
raise the washer or counterclockwise
to lower it.
Raise
No shims. It would be dangerous. If the
floor is that far from being level, it is a floor
problem and not a washer problem.
CAUTION
• The ventilating openings in the base area must not be obstructed by carpeting.
• Install the washing machine on a level and firm surface, and tilt should be less than 1˚
• Wooden floors may need reinforcing to prevent the normal vibration which occurs with an
unbalanced load.
• Do not install the washer on an inclined floor.
Improper installation of the washer may cause noise and malfunctioning.
3
4
Lower
4
Checking level
Open the lid, check if the washer is
correctly leveled by looking down
from the top. If a gap is seen
between the tub and drum, the
washer is not level.
Checking slope
If installation surface is tilted, the
washer will vibrate. Do not install
on a sloping floor.

Advertisement

Table of Contents
loading

This manual is also suitable for:

796.2927000

Table of Contents