LG 26LG30D Service Manual page 10

* After downloading, have to adjust Tool Option again.
1) Push "IN-START" key in service remote controller
2) Select "MODEL SELECT" and Push "OK" button.
3) Go To "INCH" and choice proper inch.
4) TV power turn off and on.
5) Completed selecting Tool option
3.1. ADC Process
(1) PC input ADC
1) Auto RGB Gain/Offset Adjustment
- Convert to PC in Input-source
- Signal equipment displays
Output Voltage : 700 mVp-p
Impress Resolution XGA (1024 x 768 @ 60Hz)
Model : 60 in Pattern Generator
Pattern : 65 in Pattern Generator (MSPG-925 Series,
MPSG-1025D) - 7 color bar.
[gray pattern that left & right is black and center is
white signal(Refer below picture)]
<Fig. 1> Adjustment pattern(PC)
- Adjust by commanding AUTO_COLOR_ADJUST.
2) Confirmation
- We confirm whether "0xAA (RGB)" address of
EEPROM "0xA2" is "0xAA" or not.
- If "0xAA (RGB)" address of EEPROM "0xA2" isn't
"0xAA", we adjust once more
- We can confirm the ADC values from "0xA4~0XA9
(RGB)" addresses in a page "0xA2"
* Manual ADC process using Service Remocon. After
enter Service Mode by pushing "ADJ" key,
execute "ADC Adjust" by pushing "
CALIBRATION: RGB-PC".
(2) COMPONENT input ADC
1) Component Gain/Offset Adjustment
- Convert to Component in Input-source
- Signal equipment displays
Impress Resolution 480i
MODEL : 209 in Pattern Generator(480i Mode)
Pattern : 65 in Pattern Generator (MSPG-925 Series,
MPSG-1025D) - 7 color bar.
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
G
" key at "ADC
3.2. Function Check
(1) Check display and sound
- 10 -
Impress Resolution 1080i
Model : 223 in Pattern Generator(1080i Mode)
Pattern: 65 in Pattern Generator (MSPG-925 Series,
MPSG-1025D) - 7 color bar.
- Adjust by commanding AUTO_COLOR_ADJUST.
2) Confirmation
- We confirm whether "0xB3 (480i)/0xBC (1080i)"
address of EEPROM "0xA2" is "0xAA" or not.
- If "0xB3 (480i)/0xBC(1080i)" address of EEPROM
"0xA2" isn't "0xAA", we adjust once more.
- We can confirm the ADC values from "0xAD~0XB2
(480i)/0XB6~BB (1080i)" addresses in a page "0xA2".
* Manual ADC process using Service Remocon. After
enter Service Mode by pushing "ADJ" key, execute "ADC
Adjust" by pushing " G
COMPONENT".
Impress Resolution 480i
Impress Resolution 1080i
- Check Input and Signal items. (cf. work instructions)
1) TV
2) AV (SCART1/SCART2/S-VHS/CVBS)
3) COMPONENT (480i)
4) RGB (PC : 1024 x 768 @ 60hz)
5) HDMI
6) PC Audio In
* Display and Sound check is executed by Remote
controller.
" key at "ADC CALIBRATION :
LGE Internal Use Only