7. Disconnect RF cable from IO board connector (H).
Figure 3-40. IO Board and RF Cable
IO Board Installation
1. Connect RF cable (H) to IO board connector. (Figure 3-40)
NOTE:
NOTE:
Light sensor must be secured in support plate guide.
Microphone cable must be under IO board.
2. Align IO board with bezel guides (J). (Figure 3-41)
NOTE:
NOTE:
RF cable must be secured under IO board guides (K).
J
Figure 3-41. IO Board and Bezel Guides
3. Install board on bezel.
3-30
H
K
J
Machine Maintenance Procedures
0