➢ Depending on configuration, the calibration procedure may start with a speaker
distance detection. If the distance detection is successful, room acoustic analysis
begins immediately after it.
➢ During the acoustical analysis phase, Anti-Mode generates several frequency
sweeps. After the first sweep, the initial room response graph is shown in red.
➢ It is normal that the analysis phase lasts several minutes.
➢ You can cancel the calibration process at any time by pressing the BACK button.
This will revert the room correction parameters back to their previous calibration
state. (However, possible new speaker delay values from the distance detection step
stay in effect. Please note that this behavior may change in a future firmware
revision.)
➢ Once the analysis phase is finished, the corrected room response is shown in black.
The limit of the automatically corrected range is displayed with a vertical dashed
bar. Press the OK button to dismiss the screen.
viewed later in the Room Response menu accessible from the Main menu.)
➢ Congratulations! Your system is now optimized for the most accurate sound. Press
the MENU button (or the BACK button) to return from the main menu to the home
screen.
Rev. 1.0
(Both the before and after graphs can be
2013-06-04
A
-M
2.0 D
NTI
ODE
O
WNER
C
UAL
ORE
'
M
S
ANUAL
Page 9 (32)