Yaesu FT-2900R Technical Supplement page 12

Alignment
DCS TX Deviation
Rotate the DIAL knob to set the alignment param-
eter to "B0101 dC B0101 dC." B0101 dC B0101 dC B0101 dC
Press the [ D/MR ( MW )] key to enable adjustment
of the "DCS TX Deviation."
Press the PTT switch to activate the transmitter,
adjust the DIAL knob so that the Deviation Meter
reading is 0.8 kHz (±0.05 kHz).
Press the [ D/MR ( MW )] key.
12
Closing the Alignment mode
1. Press the [DW(REV)] key to save the new setting and
exit to normal operation.
2. Press and hold in the [ PWR (
ond to turn the radio off.
3. Press and hold in the [ MHz ( SET )] key while turning
the radio on.
)] switch for 1/2 sec-