Assembling Unifence Table To Saw - Delta Unifence 36-905 Manual

ASSEMBLING
UNIFENCE TA B L E
TO SAW
1 . Remove #14 x 3/4 inch-long screw (E) Fig. 12, which
was insta l l e d i n STEP 5, page 4.
2 . Assemble Unifence table (A) Fig. 11, to brackets ( B )
using two #14 x 3/4 inch-long screws (D) and screw (E)
which was removed in STEP 1, F i g . 1 2 . NOTE: The two
screws (D) Fig. 12, can be tightened; screw (E) should
b e l e ft s l i g h t l y l o o s e a t t h i s t i m e . CAUTION: Overtight-
ening screws in particle board may cause them to strip.
3 . Using a straight edge (F) Fig. 13, make certain the
Unifence table surface is level with the saw table by
adjusting two leveling screws on bottom of table legs and
adjusting brackets ( B ) F i g . 1 4 . Then tighten three nuts
( C ) F i g . 1 4 . IMPORTA N T: Front edge of Unifence table
must be flush with or slightly behind front edge of saw
t a b l e .
Fig. 13
4 . Place the shelf support (H) Fig. 15, against table legs
and fasten with U-bolts (K), flat washers (L), and hex
n u ts (M) as shown.
F
6
F i g . 11
Fig. 12
Fig. 14
K
H
M
L
Fig. 15