Connector Pinouts - DAGE-MTI DC-200 User Manual

Focus Adjustment (mechanical back-focus)
The Back-Focus is calibrated at the factory and should not
need readjustment, however if adjustment is necessary follow
the procedure below:
1. Loosen the set screws on the top and bottom of front
casting with a 1.5mm hex wrench.
2. Set the lens to maximum aperture and to ∞ focus
position.
3. View an object which is 20M or more away, then adjust
lens mount ring until the image is in focus.
4. Tighten the set screws.
Connector pin-outs
OSD Keyboard Connector
Y/C Video Connector
This 8 pin connector is used for the OSD
Remote to set-up or change camera function
settings. The pin-out is as follows:
1. RIGHT
2. LEFT
3. UP
4. DOWN
This 4 pin connector provides Y (luminance)
and C (color) output signals to be terminated
into 75Ω. The pin-out is as follows:
1. GROUND
2. GROUND
5. MENU
6. ONE PUSH(AWB)
7. GROUND
8. N/C
3. Y (LUMINANCE)
4. C (COLOR)