Fitting The Trimmer Guard And Trimmer Head; Fitting A Blade Guard, Grass Blade And Grass Cutter - Husqvarna 525RJX Operator's Manual

Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
A
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
• To dismantle, follow the instructions in the reverse
order.
ASSEMBLY
Fitting a blade guard, grass blade
and grass cutter
B
C
A
•
CAUTION! Use the recommended blade guard. See the
Technical data section.
•
•
•
•
•
G
F
E
D
A
B
C
Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
Fit the drive disc (B) on the output shaft.
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
Insert the locking pin (C) in the hole to lock the shaft.
Place the blade (D), support cup (E) and support
flange (F) on the output shaft.
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
–
English 13