Advertisement
Maintenance
Battery
Holder
Battery
Battery
Door
Before operating the wall control,
press the battery door to eject it.
Using a Phillips head screwdriver,
Use the pull-chain switch on the
remove the battery holder. Install
fan to set the fan speed to the HIGH
the battery with the positive (+) side
position before operation.
facing downward. Secure the battery
by reinstalling the battery holder.
Finally, reinstall the battery door into
the wall control. When necessary,
replace with CR2032 battery.
Safe-Exit
Troubleshooting
The Safe-Exit Program gives
Fan will not start
you about thirty seconds of
• Make sure the power is on at the
light when you turn the lights
circuit breaker and the wall switch.
off to exit the room before the
• Make sure the battery is working.
lights go out. To use Safe-Exit:
• Make sure that the transmitter
and receiver are paired.
• Press the Fan Off button for at
• Check wire connections inside of
least three seconds to initiate the
the canopy.
Safe-Exit Mode.
Remote control of fan is erratic
• The lights will flash for visual
• Make sure the battery is installed
confirmation.
correctly.
• The lights will stay on 50%
• Install a fresh battery.
brightness for 15 seconds and
then begin to dim. After a total
Lights do not dim
of 30 seconds, the lights will be
• Check to see if a CFL bulb is
completely off.
installed. The control has a feature
Note: For CFL lighting, the lights
that automatically detects CFL
will stay on 100% brightness
bulbs and turns off dimming if a
for 30 seconds. After a total of
CFL bulb is installed.
30 seconds, the lights will be
CFL bulbs flicker
completely off.
• Turn the light switch off and back
on. Within three minutes, hold
down the Fan Off button while
pressing the Light button twice.
If the problem is not corrected,
repeat the process up to three
times.
Pairing
ON
Note:
The remote must be paired
before the fan will operate.
IMPORTANT
Within 3 minutes of restoring power
to the fan, press both the Fan Off
button and the High button for at least
4 seconds. Your fan will turn on low to
indicate successful syncing. If it does
not, turn off power to your fan, wait
1 minute then try again. If using the
transmitter with multiple fans, repeat
this process for each fan.
HUNTER FAN COMPANY CONTROL LIMITED WARRANTY
The Hunter Fan Company makes the following limited warranty to the original purchaser
of the Control ("Control"): Your Control is warranted to be free from defects in
material and workmanship for a period of one year from the date of sale. If the Control
malfunctions or fails within the warranty period due to a defect in material or workmanship
we will replace it free of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE
CONTROL, THIS WARRANTY AND ANY IMPLIED WARRANTY, INCLUDING BUT NOT
LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY IS IN LIEU OF ALL OTHER
EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING,
BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS
EXPRESSLY LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH
ABOVE FOR SUCH CONTROL. This warranty excludes malfunctions or failures which
were caused by repairs by persons not authorized by us, mishandling, improper installation,
modifications, or damage to the Control while in your possession, or unreasonable use.
This warranty does not apply to batteries or to deterioration or damage to the product
caused by the use of faulty batteries. To obtain a replacement, return your Control postage
prepaid along with proof of purchase to Hunter Fan Company Service Department at
7130 Goodlett Farms Pkwy., Memphis, TN 38016. IN NO EVENT SHALL HUNTER
FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY
NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND
YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
If you have problems installing or operating your fan, do not return this
product to the dealer. Call our Consumer Affairs Hotline.
Operations
High
Medium
Low
High
Fan Off
Fan
Off
The Fan Off button only turns the fan
off. To turn the fan on, press one of the
fan speed buttons. They are located
next to the Fan Off button.
High
ooo
Medium
oo
Low
o
1-888-830-1326
M0061-01 • 01/16/14 • © Hunter Fan Company
www.HunterFan.com
Light
Quickly press the Light button to turn
the lights off and on. Hold the Light
button to raise and dim the light level.
Read and Save These Instructions
This product conforms to UL Standard 507.
WARNINGS
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with RSS-210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures: Reorient or relocate the receiving antenna, Increase the
separation between the equipment and receiver, Connect the equipment
into an outlet on a circuit different from that to which the receiver is
connected. Consult the dealer or an experienced radio/TV technician for
help. Note: Any changes or modifications to the transmitter or receiver
not expressly approved by Hunter Fan Company may void one's authority
to operate this remote control.
1.888.830.1326
Hide quick links:
Advertisement
