Setting The Repeater Offset Frequency; Setting The Repeater Offset Direction - Radio Shack HTX-252 Owner's Manual

SETTING THE REPEATER OFFSET
FREQUENCY
Note: This setting affects only the VFO mode. If you saved a re-
peater offset in a memory, that setting is not affected.
1. Press +
F SHIFT (LOCK).
2. While the offset frequency appears, rotate the tuning control
or repeatedly press
appears. The transceiver's default repeater offset is 600
kHz, which appears as
value from 100 kKz to 8.000 MHz.
3. Press to store the setting or wait 5 seconds. The
PTT
selected value is stored and the operating frequency
appears.
SETTING THE REPEATER OFFSET
DIRECTION
1. Set an offset frequency.
2. Repeatedly press
F
offset direction ( above,
non-repeater operation).
3. Press to store the setting or wait 5-seconds. The
PTT
selected value is stored and the operating frequency
appears.
The offset frequency and
or until the desired offset
UP DN
0.60 (MHz) . You can select a
+ to change the current
SHIFT (LOCK)
below, or neither for simplex or
appear.
23