Setting The Frequency Step; Setting The Scan Орноп5; Storing Scan Skip Frequencies - Radio Shack HTX-212 Owner's Manual

SETTING THE FREQUENCY STEP
The factory default frequency step is 20 kHz. Each time you rotate
TUNE one click, or press UP or DOWN on the microphone, the fre-
quency changes by 20 kHz. When scanning, the HTX-212 scans up
or down 20 kHz per step.
Follow these steps to change the frequency step.
l.
2.
4.
Press VFO.
Press F then STEP. The HTX-212 displays St and the current
frequency step.
Rotate TUNE, or press UP or DOWN on the microphone, to
select the desired frequency step (5, 10, 12.5, 20, 25, 50, or
100 kHz).
Press MHz to save the setting.
SETTING THE SCAN OPTIONS
Storing Scan Skip Frequencies
You can store up to five frequencies for your HTX-212 to skip when
scanning. This lets you prevent the HTX-212 from stopping on
beacon or packet repeater frequencies.
1.
2.
3.
Press VFO.
Hold F for at least 1 second. FUNC flashes.
Press MR. The HTX-212 displays SC and the current scan
resume setting.
Repeatedly press А until the HTX-212 displays S1 and the
first scan skip frequency (or —-.——- if no frequency is
stored).
Select the first scan skip frequency by rotating TUNE, press-
ing UP or DOWN on the microphone, or directly entering the
last five digits of the frequency.
Press А for the next scan skip memory— 52, 83, S4, ог S5.
Repeat Steps 5 and 6 for each scan skip frequency.
Press MR to save the setting.
21