Connecting Peripheral Devices - Fujitsu Primergy RX300 S4 Start Manual

Insert the rack nut tabs from inside of the rack
3.
pillar, and hook them at the top and bottom
sides to attach the rack nuts.
�������
�����������
������
������������������
7
Install the server in the rack.
��������
����������������������������������
���������������������������������������
������������
5

Connecting peripheral devices

Peripheral devices, such as the keyboard and mouse, etc., are connected to the server in the following
order. Install wiring leaving plenty of slack for when operating the server while it is pulled out from the
rack.
Use the release tie to secure the cables that were connected to prevent them from falling.
�����������
nCable forming process
After connecting the peripheral devices, tie all the cables
and fix them with the release tie to the cable holder pro-
vided with the rack.
This forming process makes the cables easily recognizable
even when multiple servers are installed in the rack.
�����������������������
���������������������
������
����������������
����������
����������������
������������������
�������������������
�����������������
�����������������������������
���������������������������������������������������
Insert the inner rails attached to the server
1.
straight on the grooves in the slide rails.
- When inserting the inner rails, check that they
are attached to the retainers properly.
- Do not push the inner rails into the slide rails by
force. Fittings of the inner rails may be trans-
formed, and the rails do not move normally.
2. Release the locks on both sides of the inner
rails (press up for the right side and press
down for the left side), and slide the server
backward slowly to install it in the rack.
3. Insert and pull out the server from the rack
several times to check that the slide rails
move smoothly without any problems.
Be careful not to pinch your fingers or catch any
clothing when sliding the server into the cabinet.
This could cause injury.
8
Secure the server to the rack.
Install the attached blank panel to the rack, where
the server or peripheral devices are not installed.
�����������������������
������
3
����������
��������������
����������
�����������
���������
�������
����������
�����������
������������
������