Usb Cloning Procedures; Learning / Teaching A Master Tv Setup Using A Usb Memory Device / .Tlx File - LG 42LP870H Setup Manual

Commercial mode

Hide thumbs Also See for 42LP870H:

Quick reference manual (30 pages)

Quick reference manual (30 pages)

Quick reference manual (26 pages)

Table Of Contents

Table of Contents

Learning / Teaching a Master TV Setup using a USB Memory Device / .tlx File

USB Cloning Notes

• Read the IMPORTANT CLONING INFORMATION on page 36 before beginning

any cloning procedures. In particular, ensure that the Master TV Setup does not

contain a Channel Map; otherwise, Teaching will result in the Target TV(s) being

configured for FTG Mode via CPU.

• If a TV Zone # and/or a Wi-Fi Zone # (for location-specific configuration) has/

have been set in the Master TV before the Learning process is initiated, the Zone

designation(s) will be used during the subsequent Teaching process(es). This

means that in order for the "Learned" clone data with TV Zone and/or Wi-Fi Zone

assignments to be applied, any Target TVs will need to be assigned the same

Zone designation(s) BEFORE Teaching is performed. Refer to Reference section,

"Using the TV's Zoning Features," for further information. See also bullet below.

• If you intend to use the Zoning feature(s) on this TV, make sure to assign the

appropriate TV Zone # and/or Wi-Fi Zoning # as described in Reference

section, "Using the TV's Zoning Features," BEFORE continuing with the

Learning procedure below. See also bullet above. For the Wi-Fi Zoning feature,

the Master TV's wireless network connection settings also should be configured

in the IP Environment Menu before Learning is initiated.

• You may edit the filename as part of the Learning procedure; however, a file

with edited contents will not be recognized.

• It is not possible to clone a Master TV's clock using a USB memory device.

Either set a Target TV's clock manually, or use the Auto Clock setting in the TV

setup menus.

Learn Setup from Master TV

1. Ensure the Master TV is set up completely and in Pass-through Mode.

2. Insert the USB memory device into the USB IN port on the Master TV.

3. Press MENU SETTINGS on the Installer Remote to display the TV setup

menus. Use the arrow navigation keys to select/highlight the Option menu

icon, and then press the number "7" key a total of seven times to display the

USB Download Menu.

4. To gain access to the "Learn From TV" option in the USB Download Menu, key

in the password used to access the Installer Menu (Example: Press 9-8-7-6).

5. Use the Up/Down arrow keys to select Learn From TV (TLX), and then press

OK.

6. To differentiate this .tlx file from others, you can use the Up/Down arrow keys

to change the last five digits of the filename. Press OK when you are ready

to initiate Learning.

Learning status will be shown on a progress bar in a new window. When the

Learning process is complete, the USB Download menu will reappear on the

screen.

7. When Learning is done, press

Download Menu, and remove the USB memory device from the Master TV.

206-4235

on the Installer Remote to exit the USB