Table of Contents
Advertisement
Interfacing with the EQUIP Device Via a Network Video Recorder
Step 5: Launch the Web-Client to View Live Video
Document 800-07091 Rev A
07/10
HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
4.
Enter an IP Address of the device on the network.
Note
The address must be in the same address range. For example, if the PC is
192.188.1.xx, then the device should be set to a similar address, for example
192.168.1.xy.
5.
Enter the device Subnet Mask value. A value is required.
6.
Enter a default Gateway Address that connects the device to the static network. A
value is required.
7.
Click Apply.
The network settings are updated and a message displays in the status bar to confirm
the update.
Your recording vendor has the option of using either the connection methods supported by
EQUIP V1 firmware or EQUIP V2.1 firmware. If the NVR vendor has implemented EQUIP V1
connection methods, your HD4 series camera will work on those NVRs. Similarly, if the NVR
vendor has implemented EQUIP V2.1 connection methods, your HD4 series camera will
work on those NVRs. There is no user configuration necessary.
For further information, refer to the documentation supplied with your NVR or contact your
NVR network administrator.
Note
Only one user, an Administrator or a Guest, can log on to the Web-Client
application at one time. After you are logged on as an Administrator, there is
no time out until you click Logout. To allow other Administrators to log on,
you must log out when the session is done.
Note
After the IP Utility software is installed for the first time, you can change the
Administrator or Guest passwords and upgrade the firmware.
41
Hide quick links:
Advertisement
Table of Contents
