Table of Contents
Advertisement
10. Training Mode
The training mode is used to test all functions of the QTouch 15 without adding the turnover to the
reports. The report memory will not be changed and all counters remain constant. Please note
that in this mode all receipts will be automatically marked as „Training".
In order to access the training mode, a pre-programmed training clerk must be signed-in. Training
mode will remain activated until a new clerk is assigned. You will have full access to all registration
and programming functions for testing and training purposes.
11. Instructions for Use
11.1 Touch Screen
The touch screen may only be touched with fingers. The use of pens, pencils or other sharp
objects may damage the screen. No liability is accepted for such damages.
11.2 Shutdown the System
To shutdown the system, do not use the Main switch! In the menu on the display you can see in
the up right corner a Button. You have to press it and answer the following question with yes. The
system now should shutdown.
11.2 Power Supply and Interfaces
Please use the delivered power supply for the QTouch 15 only. The usage of other power supplies
may damage your system. No liability is accepted for such damages.
The interface connections should only be plugged if the system is switched off. Please note also
the maximum cable lengths of 5 meters for USB and 15 meters for RS232.
11.3 Cleaning
To clean your QTouch 15 please use a lint-free dry or slightly damp cloth only. Disconnect the
system from the power supply before cleaning. Do not use any abrasive substances or agents
containing solvents.
Special caution is required when cleaning the display. Be careful not to scratch the surface and
prevent any liquids from entering the housing.
The touch screen may only be touched with fingers. Do not use any pens, pencils or other sharp
objects which can scratch the surface. No liability is accepted for such damages.
29
Hide quick links:
Advertisement
Table of Contents
