Typical Installation Case - Epson ELPMB30 User Manual

Tape
f Typical installation case [Mounting to a Concrete Ceiling]
When installing the ceiling plates on a concrete ceiling, use four anchor bolts. Please prepare commercially available anchor
bolts.
Warning
v Make sure in advance that the concrete on which this product is installed can hold the weight and lateral
movement of the projector and ceiling mount. If the concrete is not strong enough or has deteriorated, fortify
it with reinforcing bars or something similar.
v Install the anchor bolts according to the specifications and methods of the manufacturer of the materials so
they do not come out, become loose, or shift.
v Tighten the screws firmly during installation or after adjusting the angles.
After tightening the screws, retighten them firmly and make sure that they are not loose.
v Epson accepts no responsibility for the projector and the ceiling mount falling due to inadequate installation.
Ceiling surface
Hexagon nut
Loosen these.
Cutouts
Route the cables through the
center hole of the plates.
Female type anchors
Concrete
Hexagon nut
Hanger bolts
Flat washers
Spring washers
B
Remove the tape which secures the ceiling plate
ceiling plate . Then loosen the screws (not until they come
off) that secure the plates with the ball point hex wrench.
C
Attach the ceiling plate
Set the cutouts to the screen.
Caution
Take care not to catch the cables on or between the plates.
At least 3 threads
But not more than 17 mm, otherwise it touches the
plate.
and ceiling plate on the ceiling.
and the
7