Bush BFSAT01HD Quick Start page 2

1
20° - 30°
28.2°
Install your satellite dish strictly following local
council rules and regulations.
The dish should face 28° East of South with an
inclination of between 20° and 30°. (20° for North
of the UK and 30° for the South of the UK).
5
Remove the battery cover from the remote control
and insert 2 x AAA batteries into the battery
compartment.
8b
Download Failed
Download Again Exit Menu
Should the software update fail, press the OK
button to start again.
If the problem persists, check all the
connections between the dish and the receiver.
BFSAT01HD QSG-Rev3-140308.pmd 2
2
Connect a suitable RG6 Co-axial cable with a 'F'
type connector to the LNB. Route the remaining
end of the cable through the external wall and
connect a 'F' type connector.
6
Make sure that your freesat receiver has been installed correctly
before continuing the installation
If signal strength is less than 50% please check the dish position and
cabling
74%
Press to Continue
The first install screen will appear. If the signal
strength is above 50% press the OK button to
continue. If below 50% check the dish alignment
and cable connections.
9
Postcode 2 CV21 1FF
TV Screen Size
Widescreen (16:9)
Enter your postcode then press to continue
Use the number keys on the remote control to
enter your postcode. The right arrow moves to
the next space and the left arrow deletes the
previous character. Press the OK button to
continue.
3
HD FREESAT
RECEIVER
Connect the loose end of the RG6 Co-axial cable
with the 'F' type connector fitted to the 'LNB IN'
socket on the back of the freesat receiver.
7
Make sure that your freesat receiver has been installed correctly
before continuing the installation
If signal strength is less than 50% please check the dish position and
cabling
Transport ID
Network ID 003b 090b
Waiting for software download
The Network ID and Transport ID are shown. The
new system software will download and install
automatically.
10
Postcode 2 CV21 1FF
TV Screen Size
Widescreen (16:9)
Set your screen type with then press to continue
Use the right arrow to set your screen size/type.
Press the OK button to continue.
Your freesat receiver will now autotune.
3/14/2008, 4:16 PM
4
If
a SCART
cable is used, a
standard definition
signal will be
displayed.
Connect a HDMI cable (not supplied) between
your HD Ready TV and the freesat receiver.
Connect the power adapter between the power
socket and the freesat receiver. Turn the power
socket On.
8
The receiver is updating and will reboot in approximately 3 minutes
Do not switch off the receiver
When the new system software has been
downloaded, the above screen will appear.
Do not switch off the receiver.
You are now ready to
watch tv. To learn
more about your
freesat receiver look
in the main instruction
manual.