Table of Contents
Advertisement
Firmware upgrade
Follow below procedures to upgrade firmware version.
•
Only an SD Card is supported for a firmware update.
•
Do not remove the SD Card while an update is in progress.
•
Do not operate any buttons during the update.
•
Do not turn the projector off during the update.
•
To confirm that the firmware has been successfully updated, go to
Firmware version
>
Updating the firmware
1.
Connect the containing the latest firmware to the projector.
2.
Select Settings > Advanced > Firmware Upgrade in the main menu page.
3.
Select OK to begin.
4.
After the firmware is updated, please turn off the projector.
5.
Power on the projector and check the firmware version.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu Display Time in the Settings > Advanced menu sets the length of time the
OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments.
•
Language in the Settings > Basic menu sets your familiar language for the OSD
menus.
•
Splash Screen in the Settings > Basic menu sets a preferred logo screen to be
displayed during projector start-up.
46
Operation
.
Settings
Information
>
Hide quick links:
Advertisement
Table of Contents
