Table of Contents
Advertisement
6.1
RAID driver installation
After creating the RAID sets for your server system, you are now ready to
install an operating system to the independent hard disk drive or bootable
array. This part provides instructions on how to install the RAID controller
drivers during OS installation.
Creating a RAID driver disk
You may have to use another system to create the RAID driver disk from
the system/motherboard support CD or from the Internet.
A floppy disk with the RAID driver is required when installing Windows
2000/2003 server/XP operating system on a hard disk drive that is
included in a RAID set. You can create a RAID driver disk in DOS (using the
Makedisk application in the support CD) or in Windows
To create a RAID driver disk in DOS:
1.
Place the motherboard support CD in the optical drive.
2.
Restart the computer, then enter the BIOS Setup.
3.
Select the optical drive as the first boot priority to boot from the
support CD. Save your changes, then exit the BIOS Setup.
4.
When prompted, press any key to boot from the support CD.
Loading FreeDOS FAT KERNEL GO!
Press any key to boot from CDROM...
The Makedisk menu appears.
A) FreeDOS command prompt
B) Create NVIDIAR nForce SATA RAID for Windows 2000 Driver Disk
C) Create NVIDIAR nForce SATA RAID for Windows 2003 Driver Disk
D) Create NVIDIAR nForce SATA RAID for Windows 2003 64 bit Driver Disk
Please choose A TO D:
5.
Place a blank, high-density floppy disk to the floppy disk drive.
When you insert a floppy disk with data, the utility erases all the data
before copying the RAID drivers.
ASUS KFN4-DRE
®
environment.
®
6-1
Advertisement
Table of Contents
