Audio Pro Subwoofer Quick Manual page 3

English
3. FUNCTIONS
Power switch (10):
To switch the subwoofer amplifier to ON or OFF
mode. Make sure it is turned OFF during installation.
Turn OFF the subwoofer when it will not be used for a
longer period of time.
Standby switch (5):
In Auto mode: The amplifier goes automatically into
standby mode if no signal been detected in 20 minu-
tes. If goes on automatically if signal is detected.
In ON mode: The amplifier will be constanly ON.
Main Power indicator: (9)
The red indicator shows the operation status of the
subwoofer. Red light - subwoofer is on or in standby
mode.
Power indicator: (Blue on front)
The blue indicator shows the operation status. Blue
light - the subwoofer is on.
Volume control (2):
The sound level of the subwoofer can be adjusted. Use
the Level control carefully, remember that
program material may contain very high energy.
1
2
3
4
5
6
7
8
9
10
LowPass (3):
The Lowpass crossover frequency can be adjusted
variably between 50 and 100Hz. This gives you a
unique possibility to perfectly match the Subwoofer to
your satellite speakers. The lowest frequencies will be
reproduced only by the subwoofer.
Phase adjustment (4):
The placement of the subwoofer can have effect on the
phase between subwoofer and satellites. With the
phase adjustment the phase can be switched 180
degrees.
USB charging (1)
With the accessory RX-100, audio signal can be
received wirelessly from another unit equipped with the
transmitter TX-100. RX-100 is powered by this USB
charging connector. An audio cable is connected from
RX-100 to LINE IN.
TX-100 and RX-100 are extra accessories. Please
refer further to the manuals of TX/RX-100.
LEVEL
MIN MAX
FREQUENCY
50HZ 100HZ
PHASE 180 0 0
ON AUTO
L
RX-100
DC OUT
5V 250mA
R
R L
IN
SPEAKER
LEVEL
B1.40
OUT
FUSE TYPE:
POWER ON OFF
8
CAUTION:
ATTENTION:
12
11