Download Print this page
Audio Pro Subwoofer Quick Manual

Audio Pro Subwoofer Quick Manual

Advertisement

English
CONTROLS AND INDICATORS
1
2
3
4
5
6
7
8
9
10
1) USB charging connector
Only for the extra accessory
RX-100
2) Volume control
3) Low pass crossover control
(variable 50Hz - 100Hz)
WARNING !
To reduce the risk of electric shock, do not open or remove cover or back. Do not expose this appliance to rain or moisture. In case
of malfunction consult qualified service personel.
The lightning flash with arrowhead, within an equilateral
triangle, is intended to alert the user of the presence of
uninsulated "dangerous voltage" within the product´s
enclosure; that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
LEVEL
MIN
MAX
FREQUENCY
50HZ
100HZ
PHASE
180
0 0
ON
AUTO
L
RX-100
DC OUT
5V 250mA
R
R
L
IN
SPEAKER
LEVEL
B1.40
OUT
POWER
ON
OFF
4) Phase switch
5) Standby switch
(Auto or ON)
6) Low level input (MONO)
from amplifier
7) Speaker Level input
(from amplifier)
The exclamation point, within an equilateral triangle, is intended to alert
the user of the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
CAUTION:
ATTENTION:
FUSE TYPE:
8) Speaker Level output
9) ON/OFF indicator (Red)
10) Mains switch
11) Fuse ( T1AL)
12) Mains cord (230V)
6
12
11
(to satellite speakers)

Advertisement

loading

Summary of Contents for Audio Pro Subwoofer

  • Page 1 English CONTROLS AND INDICATORS LEVEL FREQUENCY 50HZ 100HZ PHASE AUTO RX-100 DC OUT 5V 250mA SPEAKER LEVEL B1.40 CAUTION: ATTENTION: FUSE TYPE: POWER 4) Phase switch 8) Speaker Level output 1) USB charging connector (to satellite speakers) Only for the extra accessory 5) Standby switch RX-100 (Auto or ON)
  • Page 2: Installation

    You should immediately contact your dealer if the subwoofer is damaged . 2. INSTALLATION There are different methods to connect your subwoofer to a HiFi / Home Theater system. In the following we explain 2 different ways. NOTE! Do not connect the mains cord until all other installation is completed.
  • Page 3 50 and 100Hz. This gives you a unique possibility to perfectly match the Subwoofer to Turn OFF the subwoofer when it will not be used for a your satellite speakers. The lowest frequencies will be longer period of time.
  • Page 4: Troubleshooting

    By experimenting with the placement of the subwoofer, you can optimize the sound quality. One good rule is to place the subwoofer at the same wall as the satellite speakers. Never cover the subwoofer or place it where the built-in amplifier will be covered.