Table of Contents
Advertisement
10. Connecting Front Panel Cable
Attach the power LED, speaker, and reset switch connectors to
the corresponding pins. If you enable "Suspend Mode" item in
BIOS Setup, the ACPI & Power LED will keep flashing while the
system is in suspend mode.
Locate the power switch cable from your ATX housing. It is
2-pin female connector from the housing front panel. Plug this
connector to the soft-power switch connector marked SPWR.
11. JP22 FSB 800 MHz OverClocking Jumper
AX4SP-G/AX4SP-GN motherboard with Intel
FSB. However you can overclock to 800MHz FSB via JP22. The default setting is 1-2 in
normal mode. To run in 800MHz FSB, you should set Jumper to 2-3 in Turbo mode that
support 200 system bus. If your CPU only support 100/133 system bus, we strongly
recommend you don't change the default setting to avoid any CPU damage.
CPU FSB
JP 22
Normal
1-2(default)
Turbo
2-3
Pin 1
JP22 FSB OverClocking Jumper
Note: FSB 800MHz is not the standard specification of Intel 865-P chipset. You are
taking your own risk to enjoy this overclocking technology. To overclock 800 MHz FSB,
you should run in DDR 400 mode.
1
SPWR
ACPI & PWR
IDE LED
LED
ACPI LED (BLUE)
Speaker
Reset
1
NC
NC
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
®
865-P chipsets only support 400/533MHz
12. Memory Module (128-Bit DDR Dual Channel)
In the past, we used to have 64-bit memory bandwidth for memory access. No matter how
many memory modules have been installed, though capacity added, the speed of access
remains the same. With 128-bit dual channel introduced, it doubles the memory bandwidth
up to 6.4GB in advanced 128-bit mode. AX4SPE-G and AX4SPE-GN support DDR
400/333/266 with Maximum capacity up to 2 GB; AX4SP-G and AX4SP-GN only support
DDR 333/266 up to 2 GB.
5VSB
SPWR
ACPI LED-
GND
ACPILED
NC
ACPI_B
GND
RESET
GND
13. Support LAN (For AX4SP-GN and AX4SPE-GN)
On the strength of Realtek 8101L LAN controller (for AX4SP-GN and AX4SPE-GN) on
board, this motherboard provides 10/100 Mbps Ethernet for office and home use. The
Ethernet RJ45 connector is located on top of USB connectors. The orange LED indicates
the link mode, it lights when linking to network. The green LED indicates the transfer
mode and it lights when data is transferring in 100 Mbps. To enable or disable this
function, you may simply adjust it through BIOS.
128-bit DDR Dual Channel
Memory module
Note: To run dual channel speed, you
have to install the same type memory
modules in two DIMM. If you install two
different sized modules, the system only
can run in single channel mode with the
speed of lower memory module.
Green/Transfer
Orange/Link
DIMMA
DIMMB
Advertisement
Table of Contents
