Removing The Motherboard Or Bottom Case (Hp Authorized Service Providers Only) - HP 6000 Service Manual

Removing the Motherboard or Bottom Case
(HP Authorized Service Providers Only)
Required Equipment
Small Phillips screwdriver.
Small flat-blade screwdriver.
Removal Procedure
All Models
Note: When Replacing the Motherboard
If the motherboard is able to boot with the service utility boot disk (see page 2-31), you need to
transfer data by running the utility disk. Further information is located on the disk.
1. Unplug the AC adapter, if present, and remove the battery. Remove the secondary battery if one is
installed.
2. Remove these additional assemblies:
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel (page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly (page 2-13).
Top case (page 2-20).
SDRAM module (page 2-6)
Omnibook 6100 Models Only
Perform steps 1 and 2 above.
1. From the top of the computer, remove the five screws that attach the motherboard to the bottom
case.
2. Remove the screw from the LAN/modem PCI panel and lift the panel out of the bottom case.
3. Wireless models only: Disconnect the front antenna PCA flex cable from the motherboard.
4. Wireless models only: Remove the mini-PCI cover and unplug the two antenna cables from mini-
PCI card #1.
Caution
Wireless models: Be gentle when removing and attaching antenna cables from the mini-PCI card.
Damage to cables or connectors can degrade performance.
5. Bend the casing that surrounds the audio connectors outward slightly to release the connectors.
6. Lift the motherboard off of the bottom case.
2-24 Removal and Replacement HP Omnibook 6000/6100