Husqvarna 325HS Workshop Manual page 22

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
5
503 98 96-01
22
Gear
Lift the blades a little using a screw-
driver and fit the connecting rod.
Fit new felt seals.
Position the eccentric cams.
Fit the connecting rod.
Fit the wear washers.
Fit the locking plate.
Fill the gearbox 2/3 full with grease
503 98 96-01.
Fit the gearbox cover.
www.mymowerparts.com
Turn the connecting rod with the
rounded edges facing upwards and
guide in the cutting equipment.
Risk for incorrect assembly:
Position the felt seals in the two outer
compartments, see picture.
Align the connecting rod, turn by hand
and check that the blades move
without jamming.
Turn the connecting rod with the
rounded edges facing towards the
eccentric cam and guide in the cutting
equipment.
Turn the wear washer with the rounded
edges facing towards the eccentric
cam.
Avoid misalignment. Make sure the
cover sits correctly and fit the screws,
tighten crosswise.
3 mm
504 90 00-04