Advertisement
ASSEMBLY – Model No. 07701413
• Remove two nuts from the burner assembly.
1
• Insert burner assembly into burner housing as shown. Insert Venturi Tube through hole in Burner Housing as shown..
• Install the two nuts removed previously to secure the burner assembly to the burner housing.
• Attach the spade end of the electrode wire to the ignitor. Shown Inset A. The round end of the electrode wire should
protrude from the hole in the burner housing beneath the burner venturi.
Burner
Assembly
Burner
Housing
Venturi Tube
opening
• Insert Control Valve into Control Panel as shown. Be sure that the hose enters the control
2
panel from the right side.
• Install two #8-32x3/8" screws through the Control Panel and into the Valve.
• Insert Ignitor into Control Panel as shown. Be sure that the wire connector is pointed
towards the right side of the control panel.
• Install two #8x3/8" self-tapping screws through the Control Panel and into the Ignitor.
#8x3/8"
Self-Tapping
Screws
Ignitor
Burner
#8-32x3/8"
Screws
Ignitor Wire
Control
Connector
Valve
Burner
Housing
Venturi
Tube
Attach nuts
Attach spade end of
the electrode wire to
the Ignitor
Control Panel
Hose, Valve,
Regulator
Assembly
Inset A
Qty: 2
Qty: 2
#8-32x3/8" Screw
#8x3/8"
Self-Tapping
Screw
07701413 • 13
Advertisement
