Advertisement
Important Safety Instructions
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords
or adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor
away from heat-emitting appliances such as radiators or heat registers. Do not install where
excessive moisture is present. Do not plug extension cords into it. Never install electrical,
telephone, network or coaxial wiring during a lightning storm. Do not drill into any part of the
housing or open the housing for any reason. There are no user-serviceable parts inside.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety
or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
Installation
Your surge suppressor features a low profile, side outlet
design, allowing it to be mounted behind a flat panel
display while leaving the outlets open for use. One outlet
and the coaxial jacks can be rotated independently up to
90 degrees.
Connect Your Surge Suppressor to the AC Power Line: Plug the surge suppressor directly into
a 3-wire grounded, 120V AC outlet.
Check Your Surge Suppressor's Diagnostic Indicator Light: Check your surge suppressor's
diagnostic LED prior to connecting your equipment. It will indicate operational status when the
surge suppressor is plugged into a live 120V AC outlet.
"PROTECTED" LED: Indicates the surge suppression components are intact and providing
complete protection against surges. If this LED does not illuminate, some of the surge suppression
components are not functioning, and the unit should be replaced. Visit www.tripplite.com/support.
13-06-102 93-32C4-EN.indd 2
2
6/14/2013 10:34:11 AM
Advertisement
