Channel Setup; Easy Delayed Recording With The Vcr Plus+ System - Hitachi VT-FX633A Owner's Manual

Hitachi owner's manual vcr vt-fx633a

Table of Contents

Your local channels may be different from the VCR Plus+ channel codes. To get ready to record with the VCR

Plus+ system you need to assign your local broadcast and cable channel numbers to the VCR Plus+ channel

codes already stored in your VCR's memory. This is called channel setup and you do it using the on-screen Easy

Guide System and the following step-by-step instructions. Then you will be ready to begin VCR Plus+ recording,

also using the on-screen Easy Guide System.

VCR Plus+ and PlusCode are trademarks of Gemstar Development corp.

Channel setup

Before you begin

1 Look for a listing like this one in your local TV program guide or Sunday newspaper TV section. Notice the

small numbers to the right of the station name.

These are the VCR Plus+ channel numbers that you will use in the channel setup procedure.

2 Make a list of the VCR Plus+ channel numbers and the channel numbers you are receiving them on. If there

are any differences, YOUR channel numbers must be assigned to the corresponding VCR Plus+ number. (See

Example)

Note in the example that the channel numbers are the same except for 20 (received on channel 8) and 42

(received on channel 38). These two channels must be assigned.

Table of Contents