Operating Features; Controls And Functions - Kenwood TK-690H Service Manual

1. Controls and Functions

1-1. Basic Function Panel
(1) (6) (7) (19)
POWER
GRP
TX BUSY
VOL CH
(2) (3) (4) (5)
(29)
(31) (20) (21) (22)(23)
1-2. Full Function Panel
(1) (6) (7)
POWER
CALL MON SCAN
GRP
TX BUSY
VOL CH
(2) (3) (4) (5)
(29) (31) (20) (21) (22) (23) (24) (25)
CALL MON SCAN
(32)

OPERATING FEATURES

(10) (11) (12) (13) (14)
(24) (26) (28)
(25) (27)
(32) (30)
(19) (9) (8)(17) (15) (16)
MON
SP OPT A B C OST
SCN
(10) (11) (12) (13) (14)
(26)
(27) (28)(30)
SP OPT A B C OST
(1) POWER Switch
Press to turn the power ON and OFF.
(2) TX/BUSY Indicator
The TX Indicator (Red LED) shows that you are transmit-
ting.
The BUSY Indicator (Green LED) shows that the channel
is in use.
(3) Microphone Connector
(4) Volume Knob
To increase the volume level, turn clockwise (CW).
To decrease the volume level, turn counterclockwise
(CCW).
(5) UP/DOWN Knob
The function of this Knob can be programmed by the
FPU.
Function
Channel Channel selector.
UP/DOWN To increase the channel, turn CW.
To decrease the channel, turn CCW.
Group Group selector.
UP/DOWN To increase the group, turn CW.
To decrease the group, turn CCW.
(6) GR UP Key, (7) GR DW Key, (8) MON Key, (9) SCN Key,
(10)~(18) PF1-9 Key
The function of these Keys can be programmed by the
FPU.
Function
[ ] : Key top name
(18)
No No function.
Function
Monitor If [MON] is pressed once while
[MON] the RADIO is waiting for reception, of MON. (Full
all signalling* squelch is canceled. function panel)
If [MON] is held down for 2 seconds, all singalling;
noise squelch is canceled and the QT/DQT &
audio is unmuted.
Scan Start and stop the scanning
[SCN] sequence.
Public The RADIO works as a PUBLIC
Address [PA] ADDRESS amplifier.
Horn Alert When the RADIO receives a
[HA] the optional signalling calls that
are assigned to the channel, the
HA relay turns on.
Talk Around Use this function to communicate
[TA] with other operators directry,
without using a repeater.
Intercom Use this function to communicate Dual HEAD
[IC] between the HEAD1 and HEAD2
operator without transmitting.
TK-690H
Description Note
Default
setting.
Description Note
Default setting
of PF1~9.
Default setting
2 TONE/DTMF
Default setting
of SCN. (Full
function panel)
configuration
only.
( B )
5