Freqently Asked Questions - Marmitek SS13 User Manual

and the next on 8).
1. Press the top OFF button and keep it pressed. The red LED flashes
shortly. After 3 seconds the present set up is shown: 1 flash is UnitCode
1, 2 flashes is UnitCode 2 etc.
2. Release the top OFF button.
3. Now press shortly for the desired UnitCode on the same top OFF button
(1x = 1; 2x = 2 etc.) The Led flashes every time you press the button.
4. At the last time keep the button pressed. After 3 seconds the LED shows
the set-up UnitCode. Now release the button.
Change of the battery
Open the sliding drawer at the back of the switch and replace the battery.
Use an identical 3V lithium battery (type CR2032). Mind the polarity when
replacing.
APPLICATIONS
With the Marmitek X-10 SS13 wireless switch in combination with the
TM13 you can activate pre-programmed macros in the CM11 computer
interface.
You can also use the SS13 as a central operation panel for your Marmitek
installation (max. 3 unique UnitCodes.).

FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same HouseCode. To solve this problem try to change
the HouseCode of your system, or have FD10 Phase Coupler/Filter installed
at your incoming mains.
My modules will not respond to my controller.
Make sure that the HouseCode on all Modules and Controllers are set to
the same HouseCode (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13
Transceiver or Marmitek Security Console installed in your house. These
components will translate the radio signals to the Marmitek X-10 signal on
SS13 TM 7