Cleaning the air filter
Ensure the dehumidifier is turned OFF
and plug is removed from the power
outlet before performing maintenance.
NOTE: The working performance of the
dehumidifier will be greatly reduced
if the filters are clogged.
1. Remove the filter as shown.
2. Vacuum any debris from the filter.
3. Using lukewarm water and a mild
detergent wash the filter and allow
to dry.
4. Once dry, re-install the filter into
the dehumidifier.
Replacing the battery
1. Remove the screws in the four
corners of the control panel.
2. Once the screws are removed,
carefully lift the control panel to
access the the Primary Control
Board (PCB).
3. On the PCB is a CR2032 battery.
Remove the battery and replace
with a new one.
4. Refit the control panel onto the PCB.
5. Refit the four screws.
Storing the unit
Prior to storing the unit, clean filters and drain water
from the unit.
If necessary, stack machines as shown.
NOTE: Do not stack more than 2 machines high. Be
sure to secure the machines to ensure they do not fall
or move.
MAINTENANCE
CR2032 Battery