Table of Contents
Advertisement
Network disconnect
You can perform the saving operation after receiving an event of a physically disconnected
network.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Network disconnect>.
3. Specify the use of "Network
disconnect".
4. Specify the activation time and
activation condition.
For more information about <Activation
time> and <Action>, refer to "Alarm input".
(page 62)
5. When done, click [Apply (
Face detection
You can set to activate this function if a face is recognized on the monitoring screen.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Face detection>.
3. Specify the use of the face detection
function.
4. Select a sensitivity level for detecting
the face.
The higher the level is, the better the
face will be recognized.
5. Use the drag-and-drop method to
specify the face detection area.
6. Specify the display of the face detection
area.
- If you set it to <On>, the detection
area will be boxed.
7. Specify the activation time and
activation condition.
For more information about <Activation
time> and <Action>, refer to "Alarm input". (page 62)
8. When done, click [Apply (
)].
)].
English _65
Advertisement
Table of Contents
