Sonos Playbar Product Manual page 24

22
Use an awl or other sharp object to punch 4 small holes through 4 of the marked locations on the template. (If additional
3.
reinforcement is desired, 2 spare screws and anchors are included in the wall mount kit.) Placement may vary but holes
should be located toward the corners, away from center.
Remove the template from the wall.
4.
Drill pilot holes. 
5.
Because the anchors and screws are designed to be self-starting, this step is optional. However pre-drilling will result in
a more accurate installation. Refer to the table below for more information.
Wall Material
Wood Stud
Drywall (no stud)
Hard wallboard or double board
Plaster
Concrete or Brick
Pre Drill
with 1/8" (3mm) bit
with 3/16" (4.5mm) bit
with 3/16" (4.5mm) bit
with 1/4" (6.5mm) bit
with 1/8" (3mm) bit
Use Wall Anchors
No
Yes
Yes
Yes
Yes
Product Guide
Use Screws
Yes
Yes
Yes
Yes
Yes