Installation Instructions - Electrolux EHI935BA User Manual

4

INSTALLATION INSTRUCTIONS

Safety instructions
WArNING!
make sure that the appliance is not damaged because of
transportation. Do not connect a damaged appliance. If it is
necessary, speak to the supplier.
Only an authorised service technician can install,
connect or repair this appliance. Use only original
spare parts.
Only use built-in appliances after you assemble
the appliance into correct built-in units and work
surfaces that align to the standards.
Do not change the specifications or modify this
product. Risk of injury and damage to the appliance.
Fully obey the laws, ordinances, directives and
standards in force in the country where you use the
appliance (safety regulations, recycling regulations,
electrical safety rules etc). Keep the minimum
distances to other appliances and units.
Install anti-shock protection, for example install the
drawers only with a protective floor directly below
the appliance.
Protect the cut surfaces of the worktop against
moisture with a correct sealant. Seal the appliance
to the work top with no space left with a correct
sealant. Protect the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
Do not install the appliance adjacent to doors and
below windows. If not, hot cookware can be hit off
the hob when you open doors or windows.
WArNING!
Risk of injury from electrical current. Carefully obey the
instructions for electrical connections.
The electrical mains terminal is live.
make electrical mains terminal free of voltage.
Install correctly to give anti-shock protection.
Loose and incorrect plug and socket connections
can make the terminal become too hot.
A qualified electrician must install the clamping
connections correctly.
Use a strain relief clamp on cable.
Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single-phase or two-phase
connection.
Replace the damaged mains cable with a special
cable (type H05BB-F Tmax 90°C; or higher). Speak
to your local service agent.
The appliance must have the electrical installation which
lets you disconnect the appliance from the mains at all
poles with a contact opening width of minimum 3mm. You
must have correct isolation devices: line protecting cut-
outs, fuses (screw type fuses removed from the holder),
earth leakage trips and contactors.
Sticking on the seal
• Clean the worktop in the area of the cut-out section.
• B ond the sealing tape to the lower edge of the cooking
surface along the outer edge of the glass ceramic. Do
not extend it. Align the cut ends in the middle of one
side. When you have cut it to length (add some mm),
push the two ends together.
Assembly
min. 500 mm
min.
50 mm
min.
5 mm
min.
50 mm