Signal Searching; Selecting The Aspect Ratio; Temporarily Blanking The Screen - Hitachi HOME-1 User's Manual And Operating Manual

Operating (continued)

Signal Searching

ON
SEARCH OFF
SRC
VIDEO S-VIDEO COMPONENT
V SV C
VOLUME
COMPUTER
PC
AUTO WIDE BLANK MUTE
AT WID
CINEMA DYNAMIC NORMAL
CUSTOM
NOTE
• May not function properly with some input signals.
• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

ON
SEARCH OFF
SRC
VIDEO S-VIDEO COMPONENT
V SV C
COMPUTER VOLUME
PC
AUTO WIDE BLANK MUTE
AT WID
CINEMA DYNAMIC NORMAL CUSTOM
DYN NOR CUS
CIN
MYMEMORY
M1 M2 M3 M4
KEYSTONE
MENU
ENTER
ENT
ESC RESET
E

Temporarily Blanking The Screen

PC
AUTO WIDE BLANK MUTE
AT WID
CINEMA DYNAMIC NORMAL CUSTOM
CIN DYN NOR CUS
MYMEMORY
M1 M2 M3 M4
KEYSTONE
MENU
NOTE
• The temporarily blanking function will automatically finish if a button of the remote control
except the ,
projector is pressed, or if there is a change in the input signal's state.
Press the SEARCH button.
1
Cycle through input signals, displaying the images of retrieved signals. If
no signal is found, returns to the signal that was selected before the search
was begun.
COMPUTER
Press the WIDE button.
1
COMPUTER input
4:3 16:9
• At a COMPUTER input, selecting an aspect ratio may display the
message "SYNC IS OUT OF RANGE". In this case, please select one of
other aspect ratios.
VIDEO, S-VIDEO, COMPONENT VIDEO input
4:3 16:9
• At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i
(1035i/1080i)/750p, only 16:9 can be selected.
Press the BLANK button.
1
The input signal screen is shut off, and a blank screen appears. You can
set the blank screen using the menu (from the SCREEN menu,
select BLANK).
Press the BLANK button again to remove the blank screen,
and return to the input signal screen.
, , , ENTER, ESC, RESET or ON button is pressed, or if a button of
VIDEO
COMPONENT VIDEO
15:9
WIDE
S-VIDEO
SEARCH
WIDE
32:15
MOVIE-1 MOVIE-2
BLANK
19