Table of Contents
Advertisement
Basic operations (continued)
Turning off the power]
2
1
P _n P
MUTE
BLANK
AUTO
TIMER
1
Press the STANDBY/ON
button for approximately
1 sec.
• The Power indicator
wilt blink orange, then the lamp wilt turn off. Approximately
1 sec. after that, the
lamp will light orange.
• After the power
is turned off, the lamp will be cooled for approximately
1 min. and the power cannot
be turned off even by pressing the STANDBY/ON
button.
• The standby
status wilt not be entered
if the time which the STANDBY/ON
button
is pressed
is too
short.
2
Turn off the main power switch of the projector [ _ : OFF].
3
Attach the lens cap.
(Caution-)
The fan will continue nmning for approximately
1 min. after the STANDBY/ON
button is pressed.
Do not turn offthe main power switch while the lamp is on because this will shorten the service life of
the lamp.
Plug & Play
This projector
is VESA
DDC 1/2B compatible.
Plug & play is possible
by connecting
to a computer
that is
VESA DDC (Display
Data Channel)
compatible.
(Plug
& play is a system
configured
with peripheral
equipment
including
a computer
and display,
and an
operating
system.
7
[Caution')
Use the RGB cable included with this projector
when using plug & play. With other cables, pins ]
(12) - (15) are sometimes
not connected
(effective
only for RGB).
J
14
Advertisement
Table of Contents
